Independent designed solid, durable and stable frame, centroid and center of gravity are same even battery installed.
Prebuilt frame and extra accessories, built with powerful EMAX power system and open source flight controller to ensure power and customizable (RTF model can fly after battery and propellers installed).
Bright COB rear LED, different LED color can be used to distinguish copters when group flying (LED power consumption is 4W, which might decrease flying times).
All in one design to combine ESC, BEC, and flight controller for easy installation and easy replacement. Plug and play motor, easy for swapping the motor and no soldering needed.
Independent. Independent ESC and flight controller and power supply. ESC switch to perform single ESC calibration and boot pad to perform software and firmware upgrade.
Flight controller uses 32bit ARM microprocessor, fast process speed to ensure fast response.
Gyroscope, magnetometer, and accelerometer and barometer expansion port. With CPPM receiver GPS feature can be enabled(GPS module sold separately).
Support ANGLE, HORIZON, HEADFREE, MAG, HEADADJ etc modes.
Support RC Input: Standard signal, CPPM (PPM SUM) signal, PWM signal.
A low voltage monitoring and low voltage warning(Buzzer sold separately).
Use EMAX 12A ESC, support open source BLHeli and ONESHOT feature. The flight controller is based on NAZE32 Skyline32, support open source configurator Baseflight and Cleanflight.
Extra power output and power output switch for LED expansion.
Frame Size: 252mm x 260mm x 75mm
Motor: MT2204(Customization Version)
ESC: BLheli 12A 4in1(Integrate on board)
Flight controller: Skyline32(Integrate on board)
FPV transmitter: 20MW/200MW
Antenna: 5.8G Clover 3 Blade Antenna Straight Connector
FPV Camera: 1/3-inch CMOS
Battery: 3S, 1500-2200mAH 30C (not included)